Search for topics or resources
Enter your search below and hit enter or click the search icon.
Signs Your Lighting System Needs Repair
Fixtures That Stopped Working
A single dark fixture usually means a failed lamp or connection. Several dark at once points to the transformer, a zone, or a break in the cable.
Lights Dim Toward the End of a Run
The classic sign of a voltage drop. If the last fixtures are noticeably weaker than the first, the run is overloaded, or the wire gauge is undersized.
Flickering or Inconsistent Output
Flicker almost always traces to a loose or corroded connection, a failing lamp, or moisture that has found its way into a fitting.
Lights Come on at the Wrong Time
Coming on at noon, staying off at dusk, or drifting week to week points to the timer, photocell, or controller rather than the fixtures.
Foggy, Corroded, or Water-Filled Fixtures
Condensation inside a lens, green corrosion at the socket, or standing water in the housing means seals have failed and the fixture is on its way out.
Damage From Mowers or Landscaping
Cut cable, knocked-over fixtures, and lights buried by grown-in beds are among the most common causes we're called out to repair.
The Failures We Find in Existing Lighting Systems
Low-voltage lighting is a system, not a set of separate lamps. Most problems trace back to power, connections, or water — and most are fixable without starting over.
Failed Fixtures and Lamps
Burned-out lamps, corroded sockets, and fixtures past their service life replaced — including conversion of older halogen systems to LED.
Transformer Repair and Replacement
Units that hum, trip, run hot, or have simply stopped. We confirm the transformer is actually the fault before replacing it.
Voltage Drop and Overloaded Runs
Dim fixtures at the end of a line can be corrected by rebalancing the run, adjusting tap connections, or upgrading the wire.
Cut, Corroded, or Failed Connections
Buried splices are the most common failure point in any system. We locate the break and repair it with weatherproof connections.
Timers, Photocells, and Controls
Lights on the wrong schedule get traced to the timer, photocell, or controller — then repaired, reprogrammed, or upgraded.
Re-aiming, Resetting, and Restoration
Fixtures knocked out of alignment, sunk into beds, or swallowed by grown-in landscaping are reset so the design reads the way it was intended.
